Carrier 38/40GRQ Owner's Manual

40GRQ / 38GRQHigh --Wall Ductless Split SystemSizes 09 to 18 Owner' s Manual NOTE TO EQUIPMENT OWNER:Please read this Owner’s Info

REMOTE CONTROL FUNCTIONSFNote:no display9(horizontal louvers stopsat current position) buttonutton can turn on ( display " " icon) or

T-ON button “T-ON” button can set the time for timer on. After pressing this button, " " icon disappears and the word “ON"

SLEEP button15Pressing this button can select Sleep 1, Sleep 2,Sleep 3, Sleep 4 or cancel Sleep circularly as below: cancelREMOTE CONTROL FUNCTIONSPre

temperature curves. In Sleep 1 and Sleep 2, the air conditioner will run according to a group of presetting Sleep 3 - the sleep curve setting under DI

REMOTE CONTROL FUNCTIONS - COMBINATION KEYSX-FAN This function indicates moisture levels will blow away after unit stops to prevent mold.1.When X-FAN

1.After initializing unit, press the ON/OFF button on remote control to turn on air conditioner.2.3. Press "+" or " - " button to

Lost or damaged remote controlIf the remote control is lost or damaged, the air conditioner can be turned off directly from the unit. Lift the display

CLEANING AND MAINTENANCE1234Open panel..WARNINGClean filter every three months. If dust accumulates quickly, clean filter more frequently.113°F (45°C)

CLEANING AND MAINTENANCENotice for recovery1. Many packing materials are recyclable materials. Please dispose them in appropriate recycling unit.2.

TroubleshootingPlease identify problems and possible solutions for requesting maintenance assistance. If problem can not be resolved by following the

3SAFETY CONSIDERATIONSInstalling, starting up, and servicing air-- conditioning equipmentcan be hazardous due to system pressures, electrical componen

Troubleshooting burnt out? after stopping operation? Is remote control function setting correct? on the unit again. air switch or fuse.Air

Problems Possible causes SolutionsFoul odorsSources of foul odors: furniture, cigarettes, etc.Air conditioner suddenly operates normally without repai

Note: If there are other error codes, please contact qualified professionals for service.WARNINGError codeE5E8E6U8H6C5F1F2TroubleshootingIt c

Installation diagramDrainage pipeAt least 8.2 ft (250cm)At least 4.9 ft (15cm)At least 1.64 ft (50cm)At least 1.64ft (50cm)At least 0.98 ft (30cm)At l

1. There should be no obstruction near air inlet and air outlet.2. Select a location where the condensat- ion water can be dispersed easily and

Grounding requirement The Air conditioner must be properly grounded to avoid electric shock.2. The yellow-green wire in air conditioner is groundin

INDOOR UNIT INSTALLATIONStep one: choosing installation locationStep two: install wall-mounting framerm it with the client.1. Hang the wall-mounting f

1. Aim the pipe joint at the corresponding bellmouth.2. Pretightening the union nut with hand.3. Adjust the torque force by referring to the follow

4. Wrap the indoor pipe and joint of con- nection pipe with insulating pipe, and then wrap it with tape.Step six: install drain hoseINDOOR UNIT

INDOOR UNIT INSTALLATIONNote:All wires of indoor unit and outdoor uniIf the length of power connection wire is insufficient, please contact the suppli

Working temperature rangeIndoor side DB/WB( )°F/°C(°F/°C)Outdoor side DB/WBMaximum cooling115/75(46.1/23.9)Maximum heating80/-(26.7/-)75/64.9(2

INDOOR UNIT INSTALLATIONStep eight: bind up pipe1. Bind up the connection pipe, power cord and drain hose with the band.indoor unitgaspipeindoor a

OUTDOOR UNIT INSTALLATION FOR SINGLE ZONE APLICATIONS (REFER TO THE 38GJ OWNER'S MANUAL FOR MULTIZONE)CAUTION NOTE (select it acc

OUTDOOR UNIT INSTALLATION FOR SINGLE ZONE APLICATIONS (REFER TO THE 38GJ OWNER'S MANUAL FOR MULTIZONE)Step four: connect indoor and outdoor pipes

Step six: neaten the pipes1. The pipes should be placed along the wall, bent reasonably and hidden possibly. Min. semidiameter of bending the pi

Leakage detection6. Tighten the screw caps of valves and refrigerant charging vent.7. Reinstall the handle.1. With leakage detector: Check if there

Checking installationTesting unit operationItems to be checked Possible problemThe unit may drop, shake or emit noise.Has the refrigerant leakage been

1. Standard length of connection pipe4. The additional refrigerant oil and refrigerant charging required after prolonging connection pipe s

Additional refrigerant charging amount for R410A Liquid pipe(in/mm) Gas pipe(in/mm)__Cooling only(oz/ft (g/m)) Cooling and heating(oz/ft (g/m))0.2 oz

Pipe expanding methodNote:Improper pipe expanding is the main cause of refrigerant leakage. Please expandthe pipe according to the following steps:A:

air inletair outletConnection wireParts nameIndoor UnitOutdoor Unitair inletpanelfilterpower wirehorizontal louverremote controllerair outlettem.displ

Copyright 2014 Carrier Corporation S 7310 W. Morris St. S Indianapolis, IN 46231Manufacturer reserves the right to change, at any time, specifications

Instructions - programming remote and air conditionerProgramming remote controlSynch remote controls within 6.5ft (2m) from air conditioning unit. Wh

Remote controllerIntroduction for icons on display screen326510111491613121587411 ON/OFF button2+/- button3Cool button4Heat button6 I FEEL button7up d

Matching Remote ControlProgramming remote controlSynch remote controls within 6.5ft (2m) from air conditioning unit. While synching, the remote contr

Press the FAN button to adjust the fan circulation speed: low( ), low medium( ), medium( ), medium high( ), high( ), supe

REMOTE CONTROL FUNCTIONS7 buttonno display(stops at current position)between simple swing mode and fixed swing mode. During switching time,“ ”