Carrier UPFLOW 58BTA User Manual

HEATING & COOUNG58BTAUpflow/Horizontal Oil FurnaceInstallation, Start-up and Operating InstructionsFOR YOUR SAFETYDO NOT STORE OR USE GASOLIN

4. Remove the upper rear panel.5. Remove the flue collector box from the secondary heat exchanger tube flange. This exposes the inside

BLOWER REMOVALREMOVE 3 SCREWSFigure 4Blower Removal (Refer to Figure 4):1To remove the blower from the furnace:1. Turn "OFF" all utilities

MINIMUM CLEARANCE TO COMBUSTIBLES(Adequate service clearance should be provided over and above these dimensions, as required.)CLEARANCE FROM : UPFLOWH

GENERAL LAYOUT MULTI-POISE OIL FURNACE FLUE 6 0 FOR 150 FLUE 7 0 FOR 200UP FLOTGENERAL LAYOUT 150/200 MULTI-POISE OIL FURNACEFigure 7Issue 9413 20074

BAROMETRIC DAMPER LOCATIONSGOOD LOCATIONSFWRONGFIG. L'POORBAD LOCATIONSFigure 8ISSUE 941320142901 1418

FiltersA filter and filter rack is supplied with the furnace.It is NECESSARY THAT ALL FURNACES BEEQUIPPED WITH A FILTER.)When filter rack is used on s

FILTER RACK ARRANGEMENT INSTALLATIONFILTER RACK INSTALLATIONHORIZONTALFILTER RACK INSTALLATION UPFLOWFigure 9Issue 941320142901 1618

IMPORTANT: All local and national code requirements governing the installation of oil burning equipment, wiring and flue connections must be foll

In unconfined spaces in buildings of conventional frame, brick or stone construction infiltration may be adequate to provide air for combustion, venti

opening are also illustrated in Figure 7. If the bottom return is not used, a field-supplied galvanized steel filler plate should be used to

Pre-Installation Vent System Inspection:Before this furnace is installed, it is highly recommended ;"^^that any existing vent system be completel

Oil Connections:Complete instructions for installation of the fuel oil piping will be found in the oil burner installation instructions includ

once again there are studs in the nine, tweive, and three o'clock positions. It may be necessary to use two of the burner mounting nuts as "

4. The over the fire draft, which is taken through the hole that is provided in the observation door, is a measurement that is n

Figure 2MAINTENANCEThis furnace should never be operated without an air filter. Filters should be cleaned at least twice a year.To avoid per