Carrier 52PQ Installation Manual download pdf (Page 7)

• INSTALL CHASSIS IN SLEEVE (See Figures 11to

13)

1. Inspect foam gaskets (top, bottom, both sides) on

chassis. Replace foam gaskets ff torn or missing.

IMPORTANT: The gaskets combine with the sleeve

face to create a weather barrier. If the chassis is

installed in a non-Carrier sleeve, this weather bar-

rier may not be effective.

SIDE

GASKET

TOP

GASKET

FACTORY*INSTALLED

FOAM SEALS

Chassis weighs up to 150 lb, For personal protection,

seek help when lifting the unit. Lift unit by holding

unit basepan.

2. If retrofitting into a GE, Amana, Trane, or

Friedrich wall sleeve/grille, remove any ex!sting

foam seals from competitive manufacturer s grille

before installing unit.

3. Remove shipping tape from vent door. See Figure 11.

GASKET

COILTUBE

SHEETS

FIGURE 12 -- UNIT GASKETS

AND TUBE SHEETS

Failure to remove shipping tape will prevent fresh

air vent door from opening and may result in damag_

to the vent door cable.

4. Carefully remove power cord packing material

and discard.

5. Lift chassis level with wall sleeve.

6. Slide chassis into wall sleeve until foam gaskets

rest firmly against front of wall sleeve. See

Figure 12.

7. Screw chassis to wall sleeve with four 13/tin. long

screws taped to the control box. Screw holes are

located on both sides of the mounting angles of the

chassis. For Carrier wall sleeves, use the top-mast

and bottom-most screw holes, For competitive

wall sleeves, line up the correct attachment holes

on the chassis with the holes in the sleeves. See

Figure 13.

MANUFACTURER

SLEEVE

ATFAGHMENT

HOLE

(CARRIER SLEEVE)

FIGURE 13 -- CHASSIS MOUNTING

VENT SHIPPING VENT DOOR

DOOR TAPE CABLE

FIGURE 11 -- LOCATION OF SHIPPING TAPE

ON VENT DOOR

1 2 3 4 5 6 7 8 9 10 11 12 ... 17 18

Comments to this Manuals

No comments

Carrier 52PQ Installation Manual Page 7

Comments to this Manuals

Related products and manuals for Split-system air conditioners Carrier 52PQ