Carrier 321AAZ User Manual

Browse online or download User Manual for Water heaters & boilers Carrier 321AAZ. Pressure Tube Kit Installation Instructions Part No

  • Download
  • Add to my manuals
  • Print
  • Page
    / 12
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Pressure Tube Kit
Installation Instructions
Part No. 311166-755
NOTE: Read the entire instruction manual before starting the
installation.
This symbol indicates a change since the last issue.
SAFETY CONSIDERATIONS
Installing and servicing of heating equipment can be hazardous
due to gas and electrical components. Only trained personnel
should install or service heating equipment.
Untrained personnel can perform basic maintenance functions
such as cleaning coils or cleaning and replacing filters. All other
operations should be performed by trained service personnel.
When working on heating equipment, observe precautions in the
literature, on tags, and on labels attached to the unit.
Follow all safety codes. Wear safety glasses and work gloves.
Have a fire extinguisher available.
Recognize safety information. This is the safety-alert symbol
.
When you see this symbol on the furnace and in instructions or
manuals, be alert to the potential for personal injury.
Understand the signal words, DANGER, WARNING, and CAU-
TION. These words are used with the safety-alert symbol. DAN-
GER identifies the most serious hazards which will result in severe
personal injury or death. WARNING signifies a hazard which-
could result in personal injury or death. CAUTION is used to
identify unsafe practices which may result in minor personal
injury or product and property damage. NOTE is used to highlight
suggestions which will result in enhanced installation, reliability,
or operation.
FIRE, EXPLOSION AND ELECTRICAL SHOCK HAZ-
ARD
Failure to follow this warning could result in personal injury,
death and/or property damage.
Turn off gas and electrical supplies to unit before beginning
any installation or modification. Follow operating instruc-
tions on label attached to furnace.
UNIT DAMAGE HAZARD
Failure to follow this caution may result in improper and
dangerous operation.
Label all wires prior to disconnection when servicing con-
trols.
INTRODUCTION
This instruction manual covers installation of the pressure tube kit
Part No. 311166-755 in all gas-fired condensing furnaces.
DESCRIPTION AND USAGE
This pressure tube kit is designed for use when replacement of the
factory-installed tubing is required.
This kit is for use with models 320AAZ, 321AAZ, 340MAV,
345MAV, 350MAV, 351DAS, 352MAV, 355MAV, 340AAV,
350AAV, 352AAV, 355AAV, 398AAV, 398AAZ, 398BAZ,
399AAZ, 490AAV, 58DX, 58DXA, 58DXC, 58MCA, 58MSA,
58MVP, 58MTA, 58MXA, 58MCB, 58MVB, 58MTB, 58MXB,
58SX, 58SXA, 58SXB, 58SXC, 58VCA, 58VUA, PG9MAA, and
PG9MAB Gas-Fired Condensing Furnaces.
This pressure tube kit contains the following items:
Tubing (1 length to be cut to size) 3
Plastic tee 3
Clamps 18
Installation Instructions 1
INSTALLATION
1. Turn off gas and electrical supplies to unit.
2. Remove furnace door.
3. Cut tubing to proper length as required. Refer to appropriate
figure for required tubing lengths as shown in Table 1.
4. Install clamps (provided in kit) on ends of new tubes.
NOTE: Pressure tubing in units may be routed slightly different
than what is shown in diagrams. Where possible, refer to tubing
label on unit.
5. Replace all tubing called out in proper figures.
NOTE: Remove and replace 1 tube at a time. Ensure tubing is
routed in same manner as original pressure tubing.
6. Place pressure tube assembly behind casing clips (if appli-
cable). Make sure the tubes are not to be kinked or pinched, as
this will affect furnace operation.
7. Check pressure tubes to ensure connections are completed and
secure.
8. Turn on gas and electrical supplies to unit.
9. Check furnace for proper operation through 2 complete cycles.
10. Reinstall furnace door.
Cancels: IIK 340M-40-75 IIK 340M-40-87
8-05
Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.
Book 1 4
Tab 6a 8a
PC 101 Printed in U.S.A. Pg 1 8-05
Page view 0
1 2 3 4 5 6 ... 11 12

Summary of Contents

Page 1 - Installation Instructions

Pressure Tube KitInstallation InstructionsPart No. 311166-755NOTE: Read the entire instruction manual before starting theinstallation.This symbol → in

Page 2

Fig. 10—Pressure Tube Connection Diagram for Model 351DAS 40–in. Tall Downflow FurnacesMaximum Pressure Tube Length*UNIT SIZETUBE LENGTH (IN.)AB CD†E0

Page 3

Fig. 11—Pressure Tube Connection Diagram in a 40in. Tall Multipoise Furnace (Upflow Orientation Shown) forModels 352MAV, 352AAV, 58MTA, and 58MTBMaxim

Page 4

Copyright 2005 Carrier Corporation 340m4087Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without no

Page 5

Table 1—Reference Figure UsageMODEL NUMBER SERIES REFERENCE FIGURE320AAZ All 4321AAZ All 5340AAV A and later series 7340MAVA6B, C, D (prior to 2496A02

Page 6

Fig. 1—Pressure Tube Connection Diagram for Models 398AAV, 398AAZ, 58SX, 58SXA, and 58SXC FurnacesMaximum Pressure Tube Length*UNIT SIZETUBE LENGTH (I

Page 7

Fig. 3—Pressure Tube Connection Diagram for Models 398BAZ and 58SXB FurnacesMaximum Pressure Tube Length*UNIT SIZETUBE LENGTH (IN.)ABC D E FAll 5 12 9

Page 8

Fig. 5—Pressure Tube Connection Diagram for Models 321AAZ and 58VCA FurnacesMaximum Pressure Tube Length*UNIT SIZETUBE LENGTH (IN.)ABCDEAll 626644* Sh

Page 9

Fig. 6—Pressure Tube Connection Diagram for Series A Models of 340MAV, 350MAV, and 490AAVand Series 100 Models of 58MCA and 58MXA 40–in. Tall Multipoi

Page 10 - Maximum Pressure Tube Length*

Fig. 7—Pressure Tube Connection Diagram in 40 in. Tall multipoise Furnace (Upflow Orientation Shown) forModels 340MAV, 350MAV, and 490AAV Series B, C,

Page 11

Fig. 8—Pressure Tube Connection Diagram (Upflow Orientation Shown) forModels 340MAV, 345MAV, 350MAV, 58MCA, 58MSA, 58MXA, PG9MAA and 490AAV(between 24

Page 12 - Tab 6a 8a

Fig. 9—Pressure Tube Connection Diagram in a 40–in. Tall Multipoise Furnace (Upflow Orientation Shown) forModels 355MAV, 355AAV, 58MVP, and 58MVBMaxim

Comments to this Manuals

No comments