Carrier 58PHA/PHX Installation, start-up, operating and Specifications

P056623BRev. 2 09/08HANDBOOKINSTALLATION & OPERATIONonna-3'CASESNARROW MULTI-DECKGeneral Information ...

9TXVBulbEvaporatorFansCondenserFansServiceValveTXV1/4”AccessValveEvaporatorCondenserCompressorReceiverServiceValveFilterDrierTankAreaFlow DirectionDua

10CONDENSATE PUMP (connected to junc-tion box receptacle)ELECTRICAL HOOK-UPNo in-field wiring is required for installation of the ONNA - 3': all

11HOW TO ACCESS BALLASTSAn electronic ballast operates the case lamp and is located in the electrical junction box behind the front panel.To gain acce

12DEFROST & TEMP CONTROLTEMPERATURE CONTROL PROBE LOCATION(behind the 3” plug button).The ONNA uses timed-off defrost as its primary defrost metho

13DISCHARGE...1LOAD LIMIT...2 AIR FLOW...3RETURN AIR GRILL...4MODEL ONNAAIR FLOW & PRODUCT LOADINGCase

14PARTS ORDERING921222325161110371222436131781353418192015547382928336403132293273014392622171750E06E07E10E11E09MODELONNA

15 Location Number Part Descriptions 1 Pump Bracket 2 March Pump Model 3 Upper Back Panel 4 Rear Pipe & Wiring Covers 5 Lower R

APPENDIX A:WIRING DIAGRAMS

APPENDIX B:CONTROL SETTINGS

DANGERRemove hands and feet from beneath the case before the casters are removed. Failure to do so may result in serious injury when the case is lowe

XR03CX-HF.doc XR03CX& 1/2 D IGITAL CONTROLLER XR03CX 1. CONTENTS 1. Contents _____________________________________

XR03CX-HF.doc XR03CX& 2/2 dP Defrost start after Power failure: (n - y) n= the defrost clock will reset; y= start

APPENDIX C:USE & MAINTENANCE

DANGERElectrical Shock Hazard Always disconnect power to case when servicing or cleaning. HIGHPRESSUREWARNINGSwitch Off Both Power Switches Before P

WARNINGVerify Both Power Switches Are Off Before Cleaning Case.HIGHPRESSUREVerify that both switches were turned are OFF dur-1. ing pre-cleaning. Both

CAUTIONThe heating element in the evaporator pan is very hot when on.HIGHPRESSUREIn store service is limited and can be completed in just a few minute

NOTES

NOTES

09/08WARRANTYHEREINAFTER REFERRED TO AS MANUFACTURERFOURTEEN MONTH WARRANTY. MANUFACTURER’S PRODUCT IS WARRANTED TO BE FREE FROM DEFECTS IN MATERIAL

1925 Ruffin Mill Road, Colonial Heights, VA 23834Due to our commitment to continuous improvement all specifications are subject to change without noti

2Description of CasesSpecifically covered in this manual is the Model ONNA-3' narrow multi-deck merchandiser. Store ConditionsHill PHOENIX cases

3USING OUTRIGGERSHill Phoenix cases are manufactured and shipped to stores with outriggers installed on the base frame. This ensures that moving the

428 11/16 in[728.3 cm]85 9/16 in[2174.1 cm]51 5/8 in[1311.6 cm]17 5/16 in[439.4 cm]16 7/8 in[428.1 cm]12 5/16 in[312.4 cm]25 1/2 in[647.3 cm]26 1/2 in

5All measurements are taken per CRMA specifications.Electrical DataModelFans per CaseStandard FansCondenserFansDrain PumpEvaporator Pan HeaterDrain He

6INSTALLATIONBASE FRAMEFRONT PANELKICKPLATEThe ONNA-3' is shipped with most of the exterior panels and trim already installed. The only exterior

7PLUMBINGAll of the plumbing components are attached to the case at the factory; therefore, no assembly is required. The case drain is located front-

8REFRIGERATION COMPONENTSAccess Valve - Access port on the evaporator that allows service personnel to check system pressure.Accumulator - A device in