GB - 4
40SMC---N
• The manufacturer declines any liability for damage resulting
from modifications or errors in the electrical or refrigerant
connections.
Failure to observe the installation instructions, or use of the
unit under conditions other than those indicated in table
“Operating limits” of the outdoor unit installation manual, will
immediately invalidate the unit warranty.
• Failure to observe electric safety codes may cause a fire
hazard in the event of short circuits.
• Inspect equipment for damage during transport.
In case of damage file an immediate claim with the shipping
company.
Do not install or use damaged units.
• In case of malfunction turn the unit off, disconnect the mains
power supply and contact a qualified service engineer.
• Maintenance of the refrigerant circuit must only be carried out
by qualified personnel.
• All of the manufacturing and packaging materials used for
this appliance are recyclable.
• Dispose of the packaging material in accordance with local
requiremements.
• This equipment contains refrigerant that must be disposed of
correctly.
At the end of the unit’s life, the refrigerant must be taken to
special collection points or delivered to the retailer for correct
disposal.
Choosing the installation site
• The SMC---N unit has been conceived for above-ceiling
installation.
• The unit must be installed in a not easily accessible place.
• Do not install the unit below 2.5 mm.
• To install the unit at 2.2-2.5 m from the floor, use a
discharge pipe with a minimum length of 250 mm.
General information
... any obstruction of the unit air intake or supply grilles. ... exposure to direct sunshine, when the unit is operating in the
cooling mode; always use shutters or shades.
... positions too close to heating sources which may damage the unit.
Warnings: avoid...
200
220
400
250 mm
Positions to avoid:
• Exposure to direct sunlight.
• Areas close to heat sources.
• On damp walls or in positions that may be exposed to water
hazard.
• Where curtains or furniture may obstruct free air circulation.
Recommendations:
• Choose an area free from obstructions which may cause
uneven air distribution and/or return.
• Consider using an area where installation is easy.
• Choose a position that allows for the clearances required.
• Look for a position in the room which ensures the best
possible air distribution.
• Install unit in a position where condensate can easily be piped
to an appropriate drain.
(56 pages)
(6 pages)
(4 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals