Carrier 50MP62L-10R User Manual download pdf

Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.

PC 903 Catalog No. 563-013 Printed in U.S.A. Form 30GT-55SI Pg 1 6-99 Replaces: 30GT-48SI

Book 11122

Tab 1a1b3a4a5c

Installation Instructions

Part No.: 30GT910077, 30GT910078

SAFETY CONSIDERATIONS

When installing this accessory, observe precautions in the

literature and on any labels attached to the equipment, and all

other safety precautions that may apply.

• Follow all safety codes.

• Wear safety glasses and work gloves.

• Use care in handling and installing this accessory.

INTRODUCTION

The Accessory Condenser Coil Hail Guard is designed to

help protect the installed unit against harsh weather conditions

and debris. See Table 1 for specific package applications.

INSTALLATION

Step 1 —

Inspect the contents of each package for any

missing or damaged parts. (See Table 1.) File a claim with

shipping company if any item is missing or damaged, and noti-

fy your Carrier representative.

Step 2 —

Verify that the hail guard size is correct for the in-

tended unit. There are two different heights available — 44-in.

(1118 mm) and 48-in. (1219 mm). See Table 1 for appropriate

size for each unit or module.

Step 3 —

For each hail guard, loosen the 3 screws at the

top of the unit fan deck over the condenser coil. See Fig. 1.

Step 4 —

Mount the hail guards over the face of the coil

section by sliding guard slots under the loosened screw heads.

See Fig. 2. Slots are spaced to minimize gap between the hail

guard sections.

Step 5 —

Tighten the screws firmly to secure each hail

guard to unit.

Step 6 —

When all hail guards are secured, check that the

complete condenser coil face is covered and protected on both

sides of unit.

NOTE: There will be a small gap between each hail guard sec-

tion when installation is complete.

ELECTRIC SHOCK HAZARD

To avoid the possibility of electrical shock,

open and tag all disconnects before installing

this equipment.

09DK054-094

30GTN,GTR,GUN,GUR,GN,GT040-420

38AH044-134

48/50MP62L-10R

Accessory Condenser Coil Hail Guard Kit

Fig. 1 — Fan Deck Screw Locations

(Each Coil Section)

*Use the set of slots resulting in the smallest gap between sections.

Fig. 2 — Installing Hail Guard Section

(2 Sections Shown)

FAN DECK SCREWS (3)

1 2 3 4

Summary of Contents

Page 1 - Installation Instructions

Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.PC 9

Page 2 - Step 8 —

2Table 1 — Unit Application *Package 30GT910077 contains 44-in. (1118-mm) high hail guard; package 30GT910078 contains 48-in. (1219-mm) high hail guar

Page 3 - Module B

3BRACKET VIEW A LEFT CORNER MOUNT VIEW B CENTER MOUNT VIEW C RIGHT CORNER MOUNT

Page 4 - Tab 1a1b3a4a5c

Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.PC 9