Carrier Supra 650 Operations Instructions download pdf (Page 7)

62-61107-02

The following symptoms indicate exhaust gas has been inhaled :

- Blackout, intense headache, sudden weakness and sleepiness, vomiting,

muscular contractions, beating temples.

If you feel one of the above mentioned symptoms, go out and breathe fresh air.

If you notice a noise or modification of the exhaust system, immediately stop the

engine and call your service centre for checking and repair.

Environment :

Think about protection of environment during all the life of this refrigeration unit.

To prevent environmental damages NEVER release refrigerant in the atmosphere, NEVER throw

coolant, oil, battery and chemicals in the nature. It must be recuperate and recycle according to current

regulations.

When disposing this refrigerant unit do it in an environmentally sound way and in accordance with

current regulations.

CAUTION

Under no circumstances should anyone attempt to repair the Logic or Display

Boards. Should a problem develop with these components, contact your nearest

Carrier Transicold dealer for replacement.

Under no circumstances should a technician electrically probe the processor at any point, other than the

connector terminals where the harness attaches. Microprocessor components operate at different

voltage levels and at extremely low current levels. Improper use of voltmeters, jumper wires, continuity

testers, etc. could permanently damage the processor.

Most electronic components are susceptible to damage caused by electrical static discharge (ESD). In

certain cases, the human body can have enough static electricity to cause resultant damage to the

components by touch. This is especially true of the integrated circuits found on the truck/trailer

microprocessor.

3.1. Warning stickers maintenance

a. Keep the warning pictograms clean and without any obstruction material.

b. Clean the pictograms with water and soap and wipe them with soft fabric.

c. Replace damaged or missing pictograms with new pictograms available in Carrier network.

d. If a component having a pictogram is replaced by a new one, be sure that the new component

has the right pictogram.

e. Place a warning pictogram by applying it on a dry surface. Press to external sides to eliminate air

bubbles.

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

No comments

Carrier Supra 650 Operations Instructions Page 7