Carrier start-up and Instruction Manual download pdf (Page 3)

c. Discard or recycle old thermostat.

NOTE: Mercury is a hazardous waste and MUST be disposed of

properly.

3. Select Infinity Control™ mounting plastic (recess mount or

surface mount and decorative backplate if desired).

4. Route wires through large hole in mounting plastic. Level rear

plastic against wall (for aesthetic value only - Infinity Con-

trol™ need not be level to operate properly) and mark wall

through two mounting holes.

5. Drill two 3/16 inch mounting holes in wall where marked.

6. Secure mounting plastic to wall using two screws and anchors

provided.

7. Adjust length and routing of each wire to reach each wire

entry on the connector backplate. Strip ¼ inch of insulation

from each wire.

8. Match and connect thermostat wires to proper terminals on

User Interface backplate. See wiring diagram figures 12, 13

and 14.

A — Green = Data A

B — Yellow = Data B

C — White = 24VAC (Com)

D — Red = 24VAC (Hot)

NOTE: It is not mandatory that the above color code be used, but

each ABCD connection in the system MUST be wired consis-

tently. A separate ABCD Connector comes inside packaging and

should be used when connecting to the furnace (or fan coil). (See

Fig. 10)

NOTE: Insert connector properly into circuit board.

Fig. 3—Recessed Mount Backplate

A03186

Fig. 4—Surface Mount Backplate

A03187

Fig. 5—Thin Decorative Backplate

A04017

Fig. 6—Recessed Mount Assembly

A03190

Recessed terminal

block in wall 1

/2˝

wide by 2

/8˝ high

Recessed Mount

Interlocking Tabs (4)

Fig. 7—Surface Mount Assembly

A03191

Surface Mount

Backplate to wall

Interlocking Tabs (4)

Fig. 8—Large Decorative Backplate

A03188

1 2 3 4 5 6 7 8 ... 11 12

Comments to this Manuals

No comments

Carrier start-up and Instruction Manual Page 3

Comments to this Manuals

Related products and manuals for Water heaters & boilers Carrier start-up and