7
Drill with a #29 bit
Small needle-nose pliers
Volt ohmmeter (VOM)
Wire cutter/stripper
1/8" blade screwdriver
1/4" and 5/16" nut drivers with 6" extension
Completed wire lists and configuration sheets for each Universal
Controller
Universal Controller Overview and Configuration Manual
(808-346)
Installation instructions for all enclosures, power sources, and devices
The Universal Controller can be mounted in the following locations:
Panel mounted in a NEMA Type 1 enclosure
Wall mounted
DIN rail mounted in an enclosure
The Universal Controller's dimension's are 14 in H x 2.25 in W x
6.25 in D (36 cm H x 5 cm W x 16 cm D). It is recommended that
the module be installed in a NEMA Type 1 enclosure for security
purposes and to prevent damage.
The location of the enclosure or module is shown on the building
layout drawings that have been approved by the customer. Ambient
temperature in the enclosure should be -40°F to 158°F (-40°C to
70°C), and humidity should be 10% to 95%, non-condensing.
Caution: Do not install this module close to heaters, generators,
power switching devices, or other equipment that generates
electrical noise.
Before mounting the module, install the enclosure in the designated area
using the instructions provided by its manufacturer.
Installation and
Wiring
Required Tools
and References
Module
Installation
Comments to this Manuals